Welcome to SHANJING auto parts

Power Steering Pump Belt Replacement Process

1. Power steering pump belt replacement process


(1) Remove the air filter assembly based on the replacement instruction.

(2) Remove the bolts of the front support frame of the power steering pump.

(3) Remove the power steering pump bolts and unscrew the power steering pump nut.

(4) Remove the power steering oil valve pipe to the bolt of the diesel engine support frame, and loosen the power steering oil valve pipe.

(5) Turn the power steering pump clockwise to release the tension of the power steering pump transmission belt.

(6) Remove the power steering pump belt.


2. Power steering pump belt installation procedures


(1) The power steering pump belt is wound on belts of the power steering pump and the centrifugal water pump. Also, please ensure that the transmission belt is completely located in the tooth groove.

(2) Keep the transmission belt of the power steering pump in place to promote it. The bolts should be installed without tightening.

(3) Install the front support frame bolts of the power steering pump, and tighten them to 22Nm (16-inch pound-force).

(4) Tighten the power steering pump bolt to 22Nm (16-inch pound-force), and the nut to 25Nm (18-inch pound-force).

(5) Position the power steering oil valve pipe accurately on the diesel engine. And then install the power steering oil valve pipe support frame, fix the fixed bolt and tighten it to 10Nm.

(6) Install the air filter assembly based on the replacement instruction, and then complete the power steering pump belt installation.

Products
Belts for Your Car